FORMULA DRIFT TEXAS – PRO 2 FINAL ROUND | August 8th and 9th
The Final round of Formula Drift Pro 2 at Texas Motor speedway arrived quickly after round three in in Seattle. After some repairs from our incident at Evergreen Motor Speedway, we were ready to take on Texas.
This round, the schedule on Thursday was completely different than previous rounds. Instead of Pro 1 and Pro 2 alternating practice sessions, and Pro 2 qualifying occuring at the end of the day, Pro 2 practice was one long session, followed by qualifying, with Pro 1 practice occuring at the end of the day. I was excited for the change, because I felt like I would have more energy with qualifying earlier.
While I was hoping for some good luck this round, my Thursday morning started early with feeling nauceous around 4 am. Determined to push through, I headed to the track and suited up for practice. Despite feeling worn out from a rough morning, I was actually feeling very confident during practice. By my third lap, I felt like I was ready to qualify. I was putting together very solid runs and took a break around halfway through the long session to watch some of the other drivers.
After some rest and rehydration, I returned to the track for more practice. I wasn’t driving quite up to par with earlier that morning and decided to lower the pressure in the tires mounted on my Konig Hypergrams due to the higher track temperatures and loss in grip. I made a few more decent laps before pulling into my hot pit to wait for my turn in qualifying.
I lined up for my first qualifying pass and took off from the starting line. Immediately I noticed my tires spinning more than anticipated and I knew I had to adjust my driving for the loss in grip. I managed to enter into the outer zone and settle the car into a nice line leading me right past the first inner clipping point and into the second outer zone, filling it completely. I extended from the second outerzone to the second inner clipping and aimed for the final outerzone. After passing the front clip with good proximity, I transitioned and lost it. I spun and backed my car lightly into the tire wall lining the outer zone. I was devastated. The run was going so well, and now the pressure was on.
I knew I didn’t have enough grip on my first run so I decided to lower my tire pressures slightly before the second run. I didn’t want to change too much and risk having too much grip on a such a technical track. I was in my head and nervous. I lined up for my second run and took off. Again, I didn’t have enough grip but I knew I could drive through it. I set my car to angle in the first outer zone and kept it locked there to the first inner clip and into the second outer zone. My rear wheel was on the rumble strip as I exited the outer zone and towards the second inner clipping point. I realized my line was a little too shallow and “bobbled” past the inner clipping point. At that point I got in my head because I knew I couldn’t afford such a silly mistake, and because of my “bobble,” I was off line heading into the final outer zone. I try to extend my drift and push out towards the zone but I’ve lost to much speed. I push past the final clip and cross the finish with disappointment. I knew it wasn’t a good score, and I knew I could drive so much better.
At the drivers meeting, my suspicions were correct. I received a score of 54 and it wasn’t enough to get me into the top 16. While I had a rough year and didn’t finish the season the way I had hoped, I learned so much from every new experience and I have Konig Wheels to thank for that. I am looking forward to putting all of my new knowledge to use and come back stronger next year!
Kelsey Rowlings is a Konig Sponsored Professional Drift driver that competes in Formula Drift Pro 2 Series. Kelsey runs Konig Hypergrams in 17×9 et 25mm front and 18×9 et 25mm rear. The Konig Hypergram is Flow Formed.
Make sure to follow Kelsey on INSTAGRAM!
